 | Find your appropriate hardness testing product. Or use our check list and you will get a customized offer. to the checklist... > |
Fully automatic unmanned multiple sample test
- Mechanical matrix to support test components
- Hardness testing on 15 steel bars
- Component-specific magazine defined in software
- Fully automatic test run without nose cone in HV 5
- Predefined test point pattern of 4 tests per component
- Variable number of components and testmethods
- Micro-/ macrohardnesstest on baded samples
- Testseries according EN ISO 2639/ DIN EN 10328/ DIN 50 190-3
Multiple samples with different heights
- Mechanical matrix for testparts
- Hardness testing on 10 steel sections
- Test point definition and testmethod free selectable
- Component height sensored via nose cone
- Fully automatic test run in HV 10 (for example)
- Diagram of all measurement results
Multiple test of bedded samples
- Micro-/ macrohardness testing on up to 6 samples 40 mm diameter (for example)
- Test points and test rows according EN ISO 2639/ DIN EN 10328/ DIN 50190-3
- A second camera is mounted to the tester which is used to determine the starting point and for the report
- Movement to all 6 samples fully automatic
(PDF) Application example of the company "Bosch"
Hardness testing modul
- DuraPro 100 built onto the sledge system of a machine for hardness testing according to Rockwell C (HRC) on pipe rings and pipe sections.
CHD depthmeasurement on a pinion
- The M4 CHD system is a testing instrument designed to support the traditional laboratory testing
- It is possible to determine the CHD value by means of a special developed measurement by EMCO-TEST within 1 minute
- The system works with stored material curves that can be assigned to the corresponding measurement row
- Output of surface hardness (HRC or HV), case hardness depth (0,2 - 1,6 mm) and surface decarburation of the first 300 µ
(PDF) Application example of the company "ZF"
Hardness testing in bores
- N6P Internal hardness tester to determine the hardness in bores
- Measurement value display in HRC
- Diameter between 36 - 110 mm can be tested
Spur toothed flank testing
- Tooth flank hardnesstester for spur toothed wheels
- Application range between modul 2 - 35
- Measurement value display for HRC
- Not suitable for helical gear wheels (only possible with appropriate tooth width)
limited-lot / sampling test
- HR30N surface hardness determination on N3D001
- Mechanical test load application by means of lever movement
- For limited-lot respectively sampling test in receipt
Welding samples
- Welding samples in HV 5 or HV 10
- Flexible testpoints
- 100% fully automatic test cycle
- Single or multible specimen test
(PDF) Application example of the company "Liebherr"
Cylindrical work pieces
- Cylindrical work pieces can be easily clamped and tested using the optional prism-anvils.
- The hardness value is converted correspondingly by means of integrated diameter correction.
Inaccessible areas
- Hardness tests can take place without clamping.
- As seen here a Vickers test can be executed on the set toothed segment without the nose cone.
Piston spot tests
- In this example a fully automatic evaluation in HBW 2.5/62.5 takes place.
- The turret facilitates changeover to standardized Rockwell or Vickers testing within seconds.
Hardness testing modul
- DuraPro 200 installed in a machine for very rapid 100% tests on two different types of crankshaft for the automobile industry according to Rockwell C (HRC).
Offer-Checklist